How to Jig Dye Nylon Using Orco Nylosol™ Dyes
- Prepare goods as necessary.
- The following chemicals are used in the jig dyeing of nylon:
- 0.25 % owg Orco Ferrosol PT-500™
- 1.0 % owg Leveler
- 0.75-1.0 oz/gal(5.5 -7.5g/L) Ammonium Sulfate
- 0.50-1.0 oz/gal(3.75-7.5g/L) Ammonia
- Wet goods in bath at 100°F(43°C).
- Split chemical auxiliary bath over two ends at 120°F(49°C).
- Prepare Orco Nylosol™ dye solution
- Split dyestuff solution over two ends at 120°F(49°C).
- Run two ends at 160°C(71°C).
- Run two ends at 180°F(82°C).
- Run two ends at 207°F(97°C).
- Add acetic acid if necessary and run another two ends to promote exhaustion.
- Drop bath and rinse.